Two Piece Drive Shaft
Our Two Piece Drive Shaft is used in many applications where it would be impossible to run a single drive shaft because of an obstruction. In essence, wherever the drive shaft has to go around a corner. Common applications are the more extreme built Jeeps or rock buggies with an automatic transmission.
We believe our design to be the best for the following reasons:
Available in 1310, 1350 & 1410 series. Or any combination of these joint sizes.
As shown in the photo, the D2-2nd section can be made with our ultimate travel drive shaft. For applications which require a long stroke in the drive shaft.
We suggest that you obtain the pillow block/center support bearing and mount it to your vehicle then take the appropriate measurements. The bearing used is a standard 1.375" diameter, 2 bolt, pillow block bearing, with a set screw type locking - such as the Browning brand shown at this link.
We have a similar bearing available for $40.00.
The information required to order is the universal joint size required at each location and the length measurements which are the D2-1st, D2-2nd and the D2-OA.
Please keep in mind that with this type of drive shaft, it will be impossible to maintain good drive shaft geometry. You will experience some vibration issues. The amount of vibration cannot be determined prior to installing the drive shaft. Minimal joint angles will net the smoothest operating drive shaft. It is for this reason that we highly recommend this be for low speed applications only such as off road only or in a vehicle with locking hubs so the drive shaft will not be turning at a high rate of speed.
For more information or pricing please feel free to contact us via phone, fax or E-mail.